SITech Drysuit Valve System

SITech Inflation valve (push) INT'L /Seatec fitting

Ref: ALP001-25210

Price: £23.50 (Including VAT at 17.5%)

Inflation valve that rotates a full 360 degrees, and so requires a special tool set to fully tighten. These are best fitted to the drysuit using a SiTech Internal Valve port NGR shown below glued in place internally.
The hole in the suit is smaller than those required for the Apeks valves (32mm) and so the Internal Valve port shown below to maintain a water tight seal. These have the International or Seatec type nipple.
The valve is operated by pushing the recessed central button.

The valve is operated by pushing the ressed central button.

SITech Inflation Hose 80cm INT'L /Seatec fitting

Ref: ALP001-Q-ON80CM

Price: £23.38 (Including VAT at 17.5%)

This hose is a 80cm long, medium pressure hose, with a 3/8" UNF male thread 1st stage connector and the International/Seatec fitting. The clever part is that the locking Colet does not have to be pulled back when connecting the hose, it simple pushes on.

SiTech Dump Valve Adjustable

Ref: ALP001-11335

Price: £26.44 (Including VAT at 17.5%)

A very reliable valve from the inventors of them. Small in diameter and projecting only minimally through into the suit makes in very comfortable to use. Like the inflator it needs to be fitted using a SiTech Internal Valve port NGR shown below glued in place internally.

SITech Internal Valve port NGR (each)

Ref: ALP001-60852

Price: £3.53 (Including VAT at 17.5%)

A polyurathane valve patch that is glued to the inside of the drysuit with the flange pushing through the cut hole. Only suitable foe membrane drysuits and neoprenes under 3.5mm thick. The best glue to use is a single part PU ahesive.

SITech Valve tool (each)

Ref: ALP001-18222

Price: £3.53 (Including VAT at 17.5%)

To fully tighten the SITech range of drysuit valves you will need to use a PAIR of these tools.